Results 1 to 4 of 4

Thread: DOD Delete kit installation

  1. #1
    Registered Newbie

    Join Date
    Oct 2015
    Posts
    1
    vCash
    500

    Angry DOD Delete kit installation

    I have torn down the engine and in the process of having the block and heads done. New cam bearings, shop honed, all clearances checked and crank polished. I am changings and going with all new lifters, chrome alloy push rods, changing to the 3 bolt cam, new (o5) lS2 black chain and chain tensioner and Black balancer, I am changing mains, rods, head bolts to ARP. I am debating about what cam to use. I have a 2008 4x4 GMC Sierra and want to use the truck to pull an RV and also Hunting. I was thinking about a good RV cam. But I don't know which cam to run.

  2. #2
    Registered Member zo6pilot's Avatar

    Join Date
    Nov 2009
    Location
    MN
    Posts
    5,597
    vCash
    25
    id go 3/4 race with 1/2 inch lift 4 a cam...

  3. #3
    Registered Member runningmole's Avatar

    Join Date
    Feb 2004
    Location
    San Diego, CA
    Posts
    11,298
    vCash
    1005
    E-cam is proven too

  4. #4
    Registered Member Fastpace's Avatar

    Join Date
    Feb 2004
    Location
    Houston, TX
    Posts
    2,276
    vCash
    25
    Contact Brian Tooley Racing, tell them what you have and what you want to do with it. Buy whatever they say you need. One stop shop and one of the best.

    Sent from my Nexus 6P using Tapatalk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •