Results 1 to 2 of 2

Thread: ly6 engine in 1933 morris 10

  1. #1
    Registered Newbie

    Join Date
    Apr 2014
    Location
    buckinghamshire england
    Posts
    1
    vCash
    500

    ly6 engine in 1933 morris 10

    hi new to this forum
    need info on fitting an ly6 vvt engine from a 09 express 3500 van into a 1933 morris 10 saloon and using a 4l60e trans, engine not arrive from states yet so unsure if it comes with any wiring loom. I have got an e38 12630500 ecm but unsure if that can run the 4l60e trans and if the loom does come with the engine what mods are needed, will not be running any ps or ac vehicle should be around 2000 lbs when finished

  2. #2
    Ain't my first rodeo Wild Willy's Avatar

    Join Date
    May 2006
    Location
    Over the hill
    Posts
    19,161
    vCash
    2900
    You most likely will need the GM ecu or PCM in GM-speak- powertrain control module. Not just the transmission, but everything on the engine is computer-controlled. Spark timing, fuel mixture, based on sensors for engine coolant temp, air temp, mass of air flow. If you can match the engine, it is "easier"- being a relative term. They are programmable with the right equipment, a GM factory shop could re-flash the correct program on one. Should be an interesting, reliable torquey combination when you get it sorted.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •