Torques, PCM, DTC, General Information

[eboggs_jkvl]

Automatic Transmission A4
Clutch Installation Instructions
Disk Brakes
Draining & Filling Cooling System V8
DTC Codes
Engine Specifications LS1 1998 model
Engine Mechanical 5.7L
Engine Compression Test
Engine Cylinder Leakage Test
Engine Leak-Down Test
Fluid Capacities
Fluid and Lubricants
Front Suspension
Ignition Coil Wiring Colors
MAFT Settings
Maintenance Schedule Short Trip/City
Maintenance Schedule Long Trip/Highway
Manual Transmission – MM6
Rear Suspension
Strange 12 Bolt Break-in Procedure
Rear Drive Axle
1998 PCM Pin Assignments
1999 PCM Pin Assignments
2000 PCM Pin Assignments
2001 PCM Pin Assignments
2002 PCM Pin Assignments
1998 BCM Pin Assignments
PCM Idle Re-learn

(http://www.ls2.com/boggs/torques/enginetorques.htm)

[eboggs_jkvl]

Engine Controls Components Locations



http://www.ls2.com/boggs/controls/engine.jpg


(1) EVAP Canister Purge Solenoid
(2) Fuel Pulse Dampener
(3) Fuel Rail with Injectors
(4) Crankcase Vent
(5) Left Bank Ignition Coils/Modules
(6) Left Bank HO2S Sensor 1
(7) Engine Coolant Temperature (ECT) Sensor
(8) Fuel Pressure Gauge Test Connector
(9) Throttle Position (TP) Sensor
(10) Idle Air Control (IAC)
(11) Throttle Body Assembly
(12) Exhaust Gas Recirculation (EGR) Valve
(13) Right Bank Ignition Coils/Modules



http://www.ls2.com/boggs/controls/iac.jpg


(1) Idle Air Control (IAC) Motor
(2) Throttle Position (TP) Sensor
(3) Generator
(4) Throttle Body




http://www.ls2.com/boggs/controls/maf.jpg


(1) Mass Air Flow (MAF) Sensor
(2) Intake Air Temperature (IAT) Sensor
(3) Air Cleaner Housing






http://www.ls2.com/boggs/controls/mapandoil.jpg


(1) Manifold Absolute Pressure (MAP) sensor
(2) Camshaft Position (CMP) sensor
(3) Oil Pressure switch
(4) Connector to Knock sensor jumper harness



http://www.ls2.com/boggs/controls/knock.jpg


(1) Front Knock Sensor
(2) Rear Knock Sensor






http://www.ls2.com/boggs/controls/air.jpg


(1) AIR System Crossover Hose
(2) Air Inlet From AIR Pump
(3) Left Bank Check Valve
(4) Left Bank AIR Tube
(5) Right Bank AIR Tube
(6) Right Bank Check Valve






http://www.ls2.com/boggs/controls/airpump.jpg


(1) AIR Pump Location







http://www.ls2.com/boggs/controls/aircleaner.jpg


(1) Air Cleaner Housing Top Cover
(2) Seal
(3) Air Intake Duct to Resonator
(4) Clamp
(5) Air Intake Duct to Top Cover Retainer
(6) Intake Air Temperature (IAT) Sensor
(7) Clamp
(8) Air Intake Resonator
(9) Air Intake Duct to Throttle Body
(10) Mass Airflow (MAF) Sensor
(11) Isolator
(12) Air Cleaner Housing Lower Assembly
(13) Front Retaining Clips
(14) Air Filter Element Frame
(15) Air Filter Element






http://www.ls2.com/boggs/controls/aircleaner2.jpg


(1) Air Cleaner Housing







http://www.ls2.com/boggs/controls/ckp.jpg


(1) CKP Mounting Bolt
(2) CKP Mounting Location
(3) Crankshaft Position Sensor (CKP)





http://www.ls2.com/boggs/controls/o2sensors.jpg


(1) HO2S Bank 2 Sensor 1
(2) HO2S Bank 2 Sensor 2
(3) HO2S Bank 1 Sensor 2
(4) HO2S Bank 1 Sensor 1







http://www.ls2.com/boggs/controls/evapcan.jpg


(1) Evaporation Canister Location








http://www.ls2.com/boggs/controls/pcm.jpg


(1) PCM Location






http://www.ls2.com/boggs/controls/fuseblocks.jpg


(1) Fuse Block #1
(2) Fuse Block #2


Coolant level Sensor

http://www.ls2.com/boggs/controls/coolant.jpg

[eboggs_jkvl]

*-02 AN is equal to 1/8 in.
* -03 AN is equal to 3/16 in.
*-04 AN is equal to 1/4 in.
* -06 AN is equal to 3/8 in.
* -08 AN is equal to 1/2 in.
*-10 AN is equal to 5/8 in.
* -12 AN is equal to 3/4 in
*-14 AN is equal to 7/8 in.
*-16 AN is equal to 1 in.
* -20 AN is equal to 1 1/4 in.
* -24 AN is equal to 1 1/2 in.
*-32 AN is equal to 2 in.