tranny problem

[00_Z]

what could be the problem if my car goes into park , but will still roll ?, could it be the tranny ,linkage , ??. all other gears work fine.

[brokenz]

Originally posted by Fast Black Z
what could be the problem if my car goes into park , but will still roll ?, could it be the tranny ,linkage , ??. all other gears work fine.
What have you done besides the header install recently? Are you sure it's going into park? You are able to remove the key? Pull your plate over your console and see if anything is loose or broken.

First thing I would probably do actually is look under the car in the vicinity of the shifter cable and see if anything is loose (bracket) or broken (clips).

['94 Bad A Z28]

I posted a reply to this, maybe it was on LS1 though, lol... don't remember.

[00_Z]

it going into park , i can take the key out :confused:

[brokenz]

Originally posted by Fast Black Z
it going into park , i can take the key out :confused:
Check under the car then. :)

['94 Bad A Z28]

Originally posted by Fast Black Z
it going into park , i can take the key out :confused:



Re-read my reply on LS1. ;)

[00_Z]

i tried that and it worked , but popped out again i guess ?

['94 Bad A Z28]

YOu have to replace the missing bolt, lol... :D

[00_Z]

ok

[00_Z]

do you know what type of screw it is ?

[jmd]

if the shift lever on the side of the trans is going all the way forward and the trans still doesn't achieve park, the problem is in the trans., and related to the park pawl mechanicsm.

if it's not getting pushed all the way forward, you need to troubleshoot the cable and shifter; maybe just adjust things.

[SS LT-1]

it is just ur linkage the dealership here said it happens after being used so much

[skykingcory]

The linkage isn't letting the transmission to go fully into park. I had to get a hammer and tap the bracket that the tranny linkage rests on forward a little bit to let it fully engage. You can see it on from the left side of the car. It is the piece that is just a few inches from the arm that connects to the linkage which shifts the transmission.

['94 Bad A Z28]

Originally posted by Fast Black Z
do you know what type of screw it is ?



I don't remember, call a dealer and ask, then either get it from them, or go to an autoparts store and get it.