Forged 6.0 iron block buildup

[Sal2KZ28]

I am going to build a forged iron block for my Procharger setup. Would you guys mill the heads, bore the block?

Would you leave all of that alone to have the compression ratio low and turn up ther boost.

I should be able to get the heads to flow more without milling them to raise the compression ratio. I was looking at getting the 6.0 heads with the 317 castings.

What do you guys think?

Thanks

[Got Me SOM]

do not mill the heads, the reason you are going with a forged setup is to lower the compression NOT raise it!

no reason to bore out the block unless you want an all bore setup, but if you want that keep in mind you will need to do headwork to rework the chambers to match the new bore size.

[Sal2KZ28]

I plan to have some headwork dine to increase the flow

[Exotic Performance Plus]

Take a look at the Lunati rotating assemblies, which would provide you with a very durable combination. :)