what exactly is rolling the fenders....

[Mark]

and I guess I would have to do it for 315's on a 2002 SS right?

[ShisHKbob]

Dont HAVE too...its when you take the inside lip of your fenders (follow the sheet metal down, then curl your hand up and feel that really sharp edge in there, thats what people get rolled or cut ot allow the tires if during suspension travel, not to hit/get cut on it)...ALSO, have yo useen pics of the ZL1 (LS1 version), saw how the rear quarter panels flare out some, thats another way its referred as.

I wnat to get my rolled by flaring the fenderwheels...www.fenderroller.com seems to be an easy way to do it yourself. :shrugs:

[-=boM=-]

I shaved mine. Probably didn't need to but did anyway.

[02CamaroZ28]

Rolling and flaring are 2 different things. Flaring is where the actual quarter panel will be bumped out and is visable from outside the car. Rolling is just the 1/2 inch of the quarter panel that sticks out into the wheel well.

Mark

[Eugenio_SS]

I did not roll mine, the car is lowered and I race the mofo... pics in sig.
but to answer your question, rolling is just bending the lip inwards... some people use a baseball bat whilt rolling the car slowly... much cheaper solution and works great.

[jermstyle]

Mark, if you want to rent a tool from www.fenderroller.com I'll go in half with you so I can get mine done too.

I wouldn’t recommend using a bat, I've seen that go very wrong too many times.

I just ordered ground control coil overs for my SS, so it's going to be slammed and I plan to get 315's soon so.

Just my .02