View Full Version : headers
what are the best headers for a 91 z28 tpi 5.0? it has hooker catback with cutout and k@n filters.
Vettefan87
06-12-2005, 04:45 AM
I have TPIS coated Long Tube headers on my 1987 vette. I have not checked the website, but I believe they make headers for Camaros too. Check out the website http://www.tpis.com/ With my headers I received a Front Y pipe that plugs into my main cat, then I just ran the rest of my exhaust. The fit of the headers is really nice, and the coating is excellent.
Iroc-Z89
07-12-2005, 06:22 AM
if your car is a dual cat car, they no longer make stocking headers for our cars
I don't think SLP has theirs in stock, and TPIS just sells Edelblech for them at this point. Hooker makes good quality headers, in my experience.
gixxer92
12-11-2005, 05:54 PM
You should be able to get the SLP's @ www.slponline.com They are a little pricey. The hooker LT's that Jet hot sell are about the same price w/o Y pipe where the SLP's will fit to your cat back if you weld the old flange off of your cat onto the Y pipe. SLP 1 3/4" headers are a nice fit, the hookers will have you notching your lower A arm mount on the drivers side to clear the header, that and you have to lift the engine out of it's mounts to drop the LT's in. SLP's fit nice and u can buy the hardware that mounts the accessory brackets back up easy. I've had both, and if you don't want to through a lot of work get the SLP's.
zman1969
12-20-2005, 02:17 PM
i have these on my 87 T/A i like the fit and quality and they are not cheap but they are stainless steel too
Frosty
01-22-2006, 06:29 PM
I had my Hooker LTs installed in 30-45 mins. EASY. Cousin bought him some SLP's and the damn things hit the steering colum
Adict2Speed
01-31-2006, 12:17 AM
Hooker's are the only way to go
R the edelbrocks any good?
Frosty
10-05-2006, 05:34 AM
Edelbrocks are not stainless, therefore they will rust. I have everything from the headers to the whole dual cat y pipe. They have been slightly dented to clear the steering colum.
Iroc-Z89
10-13-2006, 03:36 AM
edlbrock are pretty but.. they have alot of internal machining problems... air tubes stick into the runners.. etc.
SLP or Hooker,, Hedman if needed
vBulletin® v3.8.5, Copyright ©2000-2012, Jelsoft Enterprises Ltd.