cracker
02-17-2004, 03:38 AM
I have a set of Loyd Elliot stage 2 heads that have stock valves and not milled. They are stock 2000 castings with Comp 918s. These heads were on a P1SC car that made 550rwhp and 680rwtq through a TH400 and a 12bolt with 4.10 gears. It also had a stock LS1 intake and macs. I think the hp is on the high side for a heads and cam(218/222) with 6lbs of boost car. Switching to ported 6.0 heads because the car is getting a F1R installed. $800 for fully assy heads.
I also have a set of 42.5lb injectors made by precision turbo and engine. These injectors were used for a dyno session until it was decided that 60lb injectors were needed. I would say 3 pulls on these injectors. $250 for the injectors.
PICS AT THIS LINK
http://slrs.8m.com/cjpeddy/
I also have a set of 42.5lb injectors made by precision turbo and engine. These injectors were used for a dyno session until it was decided that 60lb injectors were needed. I would say 3 pulls on these injectors. $250 for the injectors.
PICS AT THIS LINK
http://slrs.8m.com/cjpeddy/