- ****Clutch Shopping? Testimonials inside ****
- broke timing chain
- Yank SS4000
- where is the cheapest place to get a new flywheel?
- locking converter on dyno....
- OEM GM 3.73 Gears part numbers
- Master Or Slave?
- Slave cylinder connection
- getting a 12 bolt but....
- Would you reccommend getting a girdle with a stall?
- A4 Tranny Help Please... Quick
- Do I need an installation kit?
- Z06 clutch conversion
- ATTN: Doing a T-56 rebuild this week.
- Clutch is going.. what will be involved?
- How much for a Stock T56 Rebuild?
- diff between nonlock up and lockup
- Driveshaft Safety Loop Guide + Prices
- C5 Drivetrain Question
- 9in with 4ch ABS?
- 12 Bolt Cover Gasket
- Spec has done me right!!!!!!!!
- looking for a t400 t350 swap anyone do it?
- wtf is going on with my transmission?
- Transmission bouncing
- strange 12 bolt
- 3.73 or 4.10?
- wtf is wrong with my tranny?
- A4 to A3?
- How much does a series-3 carrier cost?
- A4 transmission filter kit?
- Anyone ever put 4 channel axles (reluctors on each end) in a 3 channel rear end?
- What was the website for...
- Will an LS1 T-56 work in my LT1?
- Spec3 or 4 for daily driven 408ci...?
- 1 Wheel peel
- Where can I get some install instructions for a rearend
- t56 bleeding and questions
- Gears
- converter question
- Mcleod or RAM master cylinder?
- Spec Stage 3 makes loud groaning noise on engagement
- T56 service manual, Anyone, help!
- Has anyone tore out their rear w/ an A4?
- Whats wrong with my car?
- Clutch qeustions...
- 02 formula stuck in 4th gear?????
- $100 Torsen replacment
- Driveline question V8 vs. V6 Fbodies
- Clutch stuff
- 6800RPMs+3.42s+5th gear=what MPH?
- T56 Skip Shift Solenoid
- help me with my rear!
- *** NEW Rear End Question!!!
- Grinding Help
- Rear whine only at 60-65mph?
- Bearing noise?!
- Rear end swap?
- Bellhousing off engine?
- I have a question
- Hydraulic vs. Manual
- How often to A4s break the 10 bolt?
- I think i screwed up my Tranny pretty bad...
- Would you change this clutch? pics
- Putting in a TC
- Do you guys with manuals down shift to slow down?
- Drive Shaft
- M6 problems need help bad!!!
- Where to get clutch alignment tool
- Which Driveshaft to get?
- 4L60E w/4600UY or TH400 w/4600&T-brake?
- recommended fluids
- Tranny Rebuild in Mid-Michigan
- B&M Ripper Shifter Washers
- Vigilante 4400? Any Good??
- How does a stall converter work?
- Old 12 bolt in newish f-bod???
- T-56 popping out of reverse?
- What model cars/trucks was the 1350 yoke used in if any
- Does stock length driveshaft fit 12 bolts?
- can you get a 1LE trans mount or equiv.?
- RPO codes for gear ratios
- Mcleod adjustable master adjustment
- will a 4l60 3200 stall work in a 700r4?
- Clutch Switch removal/replacement?
- A4 Dipstick reading?
- Clutch Pedal stuck to the floor STILL
- what tranny fluid for a 95 z28?
- iwantoknow
- a few clutch/tranny questions
- are the 700r and the th350 bolt pattern
- Tranny problems......
- GTO B&M Ripper Shifter!!!! HAVE ARRIVED!!!!
- Limited slip additive
- Need a new high perf. clutch, any reccomendations?
- Why weren't they putting 6 speeds in cars 20-30 years ago?
- Moser TQ arm bolts
- clutch
- Shifter/Tranny Sleeve Part #
- what does this sound like to you
- Trying to price a clutch setup.
- clutch budget help
- Bad converter or something else?
- z06 clutch?
- Motive or Strange rear gears
- How to tell: Stock shifter - is it a hurst?
- 9" specs/help
- How long will stock clutch last?
- HP Loss with 12 Bolt
- Is the tranny going out??
- Valve Body
- Need Clutch Installed
- Clutch/flywheel combo
- To much clutch for my car??
- Mac differential cover bolts too short?
- 4L60E and 500 hp..is it possible
- Break in period for stock gears?
- clutch making noise
- Break in time for gears
- Difficulty shifting into R with B&M shifter...
- Torque Converter
- s10 rear and same as camaro?
- T-56 problems
- Anyone replace tranny bearing races? -- need help
- Popping noise when turning left
- Is it Clutch or Synchros?
- They make a generic rear slip additive?
- Car studders when stopped.
- Gearing affecting odometer???
- Where to Buy? Exciter Rings
- Car is stuck in drive
- Troubleshooters Please help: Problems with tranny, now a belt squeal to go with it
- T56 Slider Keys (the 3 long ones)
- TRANNY Experts: I've spent 6k on drivetrain still doesn't work...
- Hydraulics question
- I need a new differential for my 10 bolt, recomendations?
- Got Myself an Aussie Clutch
- how is this torque converter?????
- fuddle racing converters
- Need advice on gears
- T56 3rd gear not-so-smooth sometimes
- My new Strange 12-Bolt
- Aftermarket power steering pump
- A4 10 bolt guys...
- Break in Period for motive gears?
- m6 transmission noise
- Drivetrain/rearend slack?
- Speed signal at VSS or PCM for electronic speedometer?
- Changing the fluid in the rear end..
- "Whirring" noise from SPEC Stage III
- quick tranny question
- Question about syncros
- Dot 5 as clutch fluid a bad idea?
- couple problems
- pilot bearing help Swaping A4 to M6 ???
- Speedo Registering Wrong
- 2-3 shift too hard below 170F
- Is this what happends when you lose a gear?
- what is this tube in the T56
- Well about damn time.. I got the 12 bolt in...
- Drivetrain loss in A4 F-bodies
- Total brain fart here....need help fast
- how bad are motive gears suposed to wine?
- Clutch master cylinder Question
- Grinding 3rd Gear
- Solid spacers
- Rear end fluid
- Rear end quote?
- Did my tranny....
- Moser 9 vs 12 pros and cons???
- ah wtf is it suposed to look like this?
- Want to know what comes with the SPEC III?
- will a aluminum 1LE driveshaft fit a 99 t/a?
- Spec Stage II Clutch
- tranny mount question
- ordering slave, HELP!!!
- Do I need a deep tranny pan?
- clutch bad?? PLEASE HELP
- replacing master cylinder on 98
- Just installed clutch, vibration?
- Spec 3F Installed Today
- stall install..now cant do a burnout?!
- Got 8.8 in a couple months ago
- Urgent: Transmission cooler line size
- help !! can anyone tell me what a ptc converter is
- (Help Needed) Having a problem with my Hydros
- My recommended first mods!
- Clutch Slipping????
- Spec to a Powergrip
- A4 to M6 swap tips needed
- Spec Stage 2 clutch installed? got a ????
- Stronger Parts for Tranny 6pd Rebuild ?
- In your opinion, what's the hardest on a clutch?
- Did I break my rear?
- Broken LSD?
- Buying a transmission, and I need help!
- Questions about differentials
- 8.8
- How to drop a A4 transmission
- A4 transmission line HELP PL
- 273s to 342s OR 373s?
- Can a clutch cause vibrations yet be silent?
- Can someone with an A4 fbody do me a quick favor?...
- Humm...8.5
- Transgo shift kit question.
- Flexplate
- A-4 with double shift feeling
- Deep tranny pan
- Which is stronger?
- Tremec M10 question
- Strange price increase coming soon!
- Need Help Asap!
- trany tech. inside plz.
- clutch problems!!
- Synthetic ATF?
- Torque Managment ?s
- (Who has) best $$ on Moser 12 bolt
- Shifting question
- B&M installed couple ?
- Shifter didn't want to go in reverse
- Has anyone here ever taken the stuff out of the valve body without dropping tranny?
- 4L60E wiring diagram
- new GM auto tranny 6L80
- Would I be insane...
- Pretty stupid M6 question
- 4L60E / A4 question
- Clutch took a dump, what to buy??
- 9" Ford or Strange 12 Bolt or Moser 12
- A4-M6 swap...a round about
- How wide is the rear end
- TransGO shift kit install initial impressions
- tranny experts "READ THIS"
- TCI SSF 3500 installed, a few questions
- Notchy Shifting
- Who makes gears to fit the 2 series carrier
- Changing wheel studs on a 9"?
- upgrading gears, what do i need?
- Going with a bigger converter
- M6 Owners......
- Help with my transmission
- Schaffer manual shift control
- Shim question
- Anyone using the textralia clutch?
- T56 swap question
- M6 help
- How much increased vibration is normal with a torque arm?
- Shift pattern
- Rebuild T56 under warranty?
- Which Shifter?
- A4 to M6 swap ECU flash question