- A-4 tranny durability & mods?
- Rebuilt tranny and SPEC Stage 3 are in!!
- changing differential fluid
- 95 T56 in a 2000
- Installed Pro 5.0 today
- What tranny would you go with?
- A4 Shift Kit
- Has anybody heard of Alamo Tranny's??
- Buick torque coverter
- And why is my tranny fluid turning purple?
- TH-400 x-member
- Who Builds the Baddest @ss T-56?
- Question about gas mileage reduction from new gears?
- car get's stuck in 4th gear, M6
- Reverse Grinding Question
- Rethinking 2.73 to 3.73 swap
- I can't find where this darn tranny is leakin' from!! A little help here guys? :)
- after market shifter
- Tranny swap and mod questions!!!???
- What aluminum flywheel shouuld i go with?
- Installing a Limited Slip carrier in a 10 bolt?
- Safe Temperature for A4?
- transmission tunning ?
- Spec 3 In; Shifting Problems
- 98 trans into 01
- 5th gear question... 6th seems fine
- spec stage 3 question
- Need A4 tranny suggestions
- Torque Converter/Stall
- M6 and lots of oil around the tail shaft
- yank ss3600
- question about new stall
- torque spec for driveshaft u-bolts???
- very tight vibration at 80-85 only
- Problem with 3-4 shift
- Rear end fluid...
- master cylinder rod and retainer ?
- Should I have my PY3600E stall upped to 4000?
- New Clutch Installed, When can I race?
- had anybody had there T-56 proshifted?
- Transgo shift kit question
- Serious Problems
- difference between stage 2 and 3 clutch
- Gearing Question......
- TCI Verters...
- Details on A4-->M6 conversion
- Shifting manually 1-2-D in an A4
- Transmission bound to engine during removal
- Tranny Cooler questions
- Is this mechanic correct???
- Converter Comes Unlocked...
- Do I need to upgrage my hydralics?
- Rear end question?
- m6 to a4 conversion
- Thought rear end was whining but it is really transmission
- Do I have the Spec3 X-pad?(Pic inside)
- Will I need to upgrade my rearend???
- Just got back from the dealer...please read
- People running a rear end stud/girdle inside please
- Methods to bleed a clutch?
- Fan for B&M Supercooler 24K
- Vig3200 is dead
- were is the a4 trans fluid fill hole?
- How much would it cost?
- A4 from M6 hp loss?
- Funky clutch and 6 speed!
- Isolator Cup
- clutch advice
- Question concerning Pro 5.0 shifter
- Problem with Auburn diff
- Ever seen these?
- My car is finally fixed!!!
- Pops out of 3rd
- Pics of T-56 Rebuild and Clutch Install
- When it Rains, it pours.... (Blown 10-Bolt AGAIN!!)
- i'd like to hear peoples opinion on shifters
- PYE3600 is out of balance
- rear end girdle??
- 3:73 gears
- Automatic Transmission Shift Knob
- Anyone get the Spec
- How much HP do 12 bolts rob?
- Which clutch....
- Leaking transmission fluid?
- 8.8 or 12 bolt
- Clutch stuck
- ? About Converter and Temperature
- Slicks on a 10 bolt?
- Need help ASAP please!!
- HELP - bad clunking noise
- 00 6spd TA - think the rear left wheel bearing is toast
- 4L60E question.
- How much should it cost...
- A4 question
- The right TC for an 02 Z
- Sanity Check my clutch decision, please.
- Clutch Disengagement Point...
- Clutch problem??
- Clunk in Reverse, Dealer Says A-Ok?
- How does the fluid get to the TC and back?
- ? About Changing Fluid
- Slipping clutch and wheel hop = related? Maybe. come inside
- 4L60E bangs from a roll, but not dig.
- PTC Torque Converters
- Auto and 10 bolt question...
- gears with a 3500 stall
- T-56 input shaft ?
- ? About Rear Bolts
- rear end went byebye!
- Grinding shifting into second
- Anyone want to guess this tranny problem?
- Hydraulic clutch fluid
- Where can I buy a clutchmasters clutch?
- ¨ Parts ¨ Help ¨
- LSS/SQS/Jarrod - difference?
- what kind of clutch?
- Spec clutches
- shift knobs!!!
- Throwout Bearing making weird noise???
- Aluminum Flywheel - Pros?
- Did my clutch just explode?
- noticed more "play" in drivetrain after 4.10 install....
- Contact Midwest??
- Predator v.s. Trans Go
- m6 shifter wont go in reverse....HELP!!!!
- 12-bolt gears??
- Replacement TC bolts?
- What just fell out of my Tranny?
- Tranny Auestion
- Anyone use this place? Good Price.
- Getting TC Restalled Need advice
- 4000 Tci Stall
- How much fluid in a T56?
- I need help
- Shifter or Tranny problem>
- Tranny or converter problem??
- 12 Bolt questions?
- Master cylinder or slave cylinder?
- Z06 clutch? Aluminum or steel flywheel?
- Torque Converter noises?
- Transgo shiftkit opinions?
- My axle?
- SPEC stage 2 or Centerforce dual???
- What Difference?
- Rear end making noises, CLUNKs around corners
- Replacing shift knob
- backlash woes :(
- Will 3rd gen 12 bolt rear work in 4th gen?
- ***Serious Help Needed!!!!***Transmission Not Engaging gears
- What just happened?!?!? Car won't go into ANY gear.
- aluminum flywheel...yes or no?
- difficulty of clutch,flywheel,hydraulics install
- Any year z06 clutch is fine for 98 ls1?
- Another rear-end thread (long)
- Beefing up a 10 bolt??
- 4L60E shifting problems surface at track, please watch video!
- Not locking into park?
- Crunching/Grinding 3rd gear
- Transmission Mount
- Quick simple Question
- How hard to replace reverse gear in T56?
- Question about backlash..
- Swapping rears
- Removing backing plates from rear
- 12 Bolt info needed quick
- How do I remove the bushing
- free short stick
- BM Ripper Question
- please help me guys - PLEASE!!!
- T/A cover Stud kit torque procedures
- Rear end swap... will this work?
- 3rd gear problems
- Need help with my clutch
- Rear End
- LS6 clutch...which parts to buy from gmpartsdirect?
- 3rd gear acting up
- Rear end plug??
- Clutch help needed
- WTF.. Reverse is SUPER hard to get too
- 10 Bolt Question
- Rear End,
- 01-02 slave/master...
- Hitting walls/crunching into gear.
- so.. whats up with the 4l60e?
- Which Transmission Pan?
- Squeaking clutch when not fully engaged?
- Just a heads up on Pinion Seals for the 10 bolt
- Can anyone track down the availability of these parts?
- Poll: What rear end would you recomend
- Clutch pedal staying near floor under load
- Shimming...
- Clutch
- Spec 3 install
- Drill mod Q's
- Newbie Clutch Questions
- Does GM consider a throwout bearing a wear item?
- HELP: just installed a clutch and....
- Clutch peddle fell to the floor
- So what's an A4 supposed to shift at?
- Okay the all out clutch thread...
- How strong is a dana 60
- Art Car Tranny, Any Thoughts?
- Noisy clutch pedal...
- LT1 tranny question
- rear end compatibility?
- slp short shifter
- ~*~*OFFICIAL MODS MARKER*~*~
- Clutch/Slave cyl problem or adjustment?
- car acceleration, is it torq managment?
- Moser 12 bolt or ford 9" ??? HELP!!!
- Help with transmission!!
- Why doe it have to be so difficult on buying a clutch?
- Chattering noise in 4th gear with B&M Ripper....
- Tuning w/ 3000 Stall
- Clutch engagement noise?????
- Tranny Cooloer
- Driving w/ spec stage 3
- th400 4000 tci stall
- Bleeding the clutch..
- 373 or 410 gear
- Differential
- Toasted the stock clutch this weekend
- What is the preferred method to keep the flywheel still?
- 4L60E trans brake???
- Getting an M5/M6 Built?
- pilot bearing...WTH!!
- preferred method on putting trans in (MN6)
- Need writeup for TC Install
- Just finished the Spec stage3 install...
- i got a question for those who know about manual transmissions
- gear ratios
- Tailshaft cracked?
- gm synchromesh
- Ford 9 Inch Question
- Lost a read differential cover bolt
- Step Inside and Help me with My Rear!
- yoke tool
- Wrecked the TA, Have a question
- 12-bolt install question....
- gears for turbo?
- Anyone who has done a 2.73 to 3.73 swap
- LS1's & Centerforce clutch.....the positives
- I need the lowdown on stall converters, LONG
- What should i do??(about my rear end)
- Transgo kit, level 2, or 3 ?
- ST3500 to ST3800, what did you gain?
- Transmission Seal leaking
- Drive Train Lash???
- I've got a BAD feeling about this...
- Camaro00_SS has Tranny Woes Let's help him!