View Full Version : LS1 / LS6
Pages :
1
2
3
4
5
6
7
8
[
9]
10
11
12
13
14
- Having backfires and slow acceleration
- look what just came...
- Just Bought a Cam & Kit - What Will Redline Be?
- MTI Billet TB and LS6 Intake
- dropped a valve and scarred cyl #3 looking for some answers
- Does flycutting the pistons make them more prone to failure?
- Will An Ls6 Work In An 02 Z28
- Lanes true Duals will fit on Flowtech
- Did a search, no help need gates part #
- just got a visit from the ups man
- Precision Race Components Head Pics & Detailed Specs
- which heads....
- fuel line sizes
- Car is running hot
- New MTI TB Pics and Kook's Clearance Pics Too
- 04 LQ4 cam specs
- Finally doing the headers tomorrow.
- fAST/WEIND INTAKE MANIFOLDS
- Flowmaster Exhaust Installation (Rattle'n)
- Fuel pump/Injector ?
- Unique oil question for Patman and co.
- Freakin Mad With Futral Motorsports
- Cam Damage
- What do you think about this cam & tune?
- How hot are EGR gases?
- FedEx man was nice to me!!
- Anytips for taking O2's out of stock exhaust?
- "Will your motor run on pump gas" (SCR/DCR)
- Anyone here using the SLP ported tb?
- Cam and Head questions
- Wrong Headers
- Belgium Castrol?
- Installing lanes true duals??
- Weekend sale - 10% off all headers/exhausts!
- Magnaflow Cats
- TSP Y Pipe owners....in here...
- QTP's and clearance....
- head gasket and compression ratio question
- Kooks header + true dual install finished, pics inside
- Car is whistling?!
- Where to get "sleeve" type exhaust clamps
- Valve Spring Question?
- Braided Fuel Lines...
- valve choice
- Will Longtube Headers increase gas mileage?
- Installing Guages
- Larger valve questions
- Me and Buddies Magnaflow catback pics
- i need fuel system help. need to upgrade? what to buy?
- can oil pan gasket be changed w/ engine in car?
- Timing chain question.
- Why does the car shift at <6000rpms?
- coolant leaking out of oil filter? headgasket?
- A cam for a friend
- True duals: Some helpful info for those curious
- I have a question
- Bosch O2 sensors
- Need Help in a Serious Way!!
- Help! Low Power after Cam + Tune
- My ASP Pulley seperated! :(
- Where did you guys get your K&N Oil filters?
- Headers are on!
- TTS Headers
- Ok guys, you're the experts. What is wrong with my car.
- Hey Guys, If you've been wanting to try Mobil 1 5000mile AZ has a killer special
- New LS2 with Patriot Heads!!!!
- Pacesetter ?
- Bassani Headers?????
- How difficult is it to replace throttle cable?
- Issues with the proper belt for a ASP pulley
- Overheating Problem! HELP ASAP!
- just got heads, now i've got questions...
- Parts List (Cam)
- Help with Valvetrain component options
- Futral Motorsports..
- Do I NEED O2 simms with an off road Y pipe?
- Replacing just the muffler?
- Cam Question
- Cam postion sensor high error after cam swap
- cat question
- for my WS6: Magnaflow or SLP Loudmouth?
- when is the LS1 broken in?
- A4 h/c swap, locking flywheel?!?!
- Torquer 2 Dyno Results
- Does Lane still have a website?
- Header question: coated or stainless in florida?
- ASP vs. SLP pulley
- header clearance for changing oil???
- question about duals and turndowns???
- Timing??
- which cat?
- Cam HP Question
- why is my exhaust so raspy?
- New Patriot Head Flow Numbers
- Injector Sizing
- would this be a good setup?
- Dynomax bullets
- Stainless Works exhaust for '05 GTO with Sport Appearance Package
- Best cam for a slightly modded 5.3L DD
- Best place to purchase complete LT exhaust system
- Just Ordered.....
- Patriot Heads Win at Grattan Raceway
- If you had Headers installed, check this out
- How many miles can you get out of an ls1?
- Pinging noise at high RPMs....
- how much does it usually cost to get an exhaust put on???
- I found where my noise is comming from...
- LS2 Intake
- Small & Large Hp Short Blocks Now Available!!!
- Whats the best way to drain coolant from an LS1 when removing heads?
- spark plugs & coils
- Need help... PLEASE..... Anyone
- need some head help
- Crane 1.8 rocker install help
- What is the head deck thickness of a stock LS1 head?
- Lifters
- Fuel filter update
- Kooks headers?
- ls1 cam swap
- weird idling problem (not LSx) while in gear
- Oversized Thrust Bearing??
- SLP HO Hood Owners
- webpage ?
- Kooks Vibration..??
- ASP pulley
- how to do a headers install
- Best spark plug wires
- Approx. Cost of header/ORY installation
- UnderDrive pulley cooling probs? Probs?
- Installing heads with LTs on ramps?
- vacumn leak around intake
- another damn squill from ac
- new mods for the car!
- cam swap
- Cleaning head gasket graphite on block
- Car buildup
- Last step of my true dual set up...
- exhaust q
- Running Rich...i think
- Big power in an A4
- Question for Kooks and y owners...
- help! exhaust?
- REV dual valve springs
- Big power in an A4........Part 2
- Lingenfelter GT-9 cam
- I need help!!
- Ugh! Lack of Power in 2000 WS6
- Question About Colder Range Spark Plugs
- Recommendations on C5 exhausts
- Drove through lots of water...are my o2s damaged?
- stock ls1 tb flow numbers
- help now headers
- Fuel Line Quick Disconnect Tool
- Oil analysis results (July 21), 8k on German Castrol
- plugs and wires
- New fuel pressure regulator design: Opinions Please
- what's wrong w/ my car! power loss?
- SLP Loudmouth failed Texas state inspection
- new headers on now funny poping sound
- Pulley install problem
- SLP Y pipe
- noisy after oil change
- Hardened Pushrods w/ a TR230?
- Rattling tensioner?
- My F10 cam is in !!! (pics inside)
- dumb cam question
- lpe gt2-3 cam question
- QTP Y pipe alternatives?
- vinci/crane LSx shaft mount rocker spy photos
- Best valve spring tool?
- O2 sims
- Dents in primaries
- Need Help Asap!!!!
- Compression test
- Stock tips with aftermarket catback?
- Question on oil psi/gauge accuracy
- Patriot Performance
- LS1 to LS2 Conversion Harnesses
- GMMG with Pacesetter LT's
- Headers install in Jax,fl.
- ls1 exhaust mods
- 98 Corvette leaking gas under engine.
- Harland 1.7’s
- So guys what do you think about this?
- ac spark plugs
- Gains with cam install?
- Cooling Problem?
- oil in throttle body,bellows, intake...what the!?!?
- Overheating Problem
- LS1 Fuel Filter Replacement
- retainer question
- duals... cats or no, what muffler?
- Patriot Stage II 5.3 heads now $1,095 Assembled
- daily driving? yes/no
- Could a bad EGR valve cause a car to quit running?
- Interstate MGP = In-town MPG?
- Need help with duals, X or H pipe
- people with duals come in
- what type of wrench...remove solenoids star headed bolts from starter??
- Cam gear bolts. Part number???
- what's the mathimatical formual for finding the exact location for a rear o2 bung
- can JP cold weld compound be used on a y-pipe
- Which cam is best for my setup?
- Cam change...so what else
- Anyone have sound clips for H pipe with sweet thunders?
- What is WOT?
- Looking for anyone who has H pipe on their LS1
- Is this a good deal??
- custom y-pipe /flowmaster y-collector what size out?
- Best/Cheapest Place to Buy Magnaflow
- H/C Swap finally finished this weekend.
- People With True Duals
- Time between Cam install and tune
- B&B triflo with pacesetter headers
- Maybe you guys can tell me...
- fuel system
- Oil Gauge Question
- SCAT Rods
- Better performance gainer??
- True Duals: What are my options?
- Need help with Hypertech power programmer
- bout to install pacesetter LT's w/ tsp ory..couple a stupid questions
- Last part of the big install coming today
- Finally, my H/C combo is in!!
- cam
- who's got glasspacks after the muffler to reduce nosie
- who has wrapped the muffler/glasspack material for nosie reduction
- Dropped a lifter
- how the f***
- Stock 02 SS what is the best way to get up to mid 400 hp N/A?
- I Want A Cam
- Should I replace this Knock Sensor?
- Bassani True Dual
- Corsa? GMMG? help!!
- Got the car back today from cam/lt install
- engine build up
- LT's, ORY Into A Single Sweet Thunder?
- Broken valvespring or something else???
- Spring options for 1.85 rockers and Z06 cam?
- intake part number
- how much does an LS1 weigh?
- injectors
- Bullet muffler
- whats the law on elec. cutout ?
- header gaskets recommended?
- strongest block for a stroker
- Patriot Performance Announcement
- Weird sound in the engine!! (after mods)
- building an on road y-pipe/cats & LTs need advice
- welding collector rings to front of cats how much of an angle is OK
vBulletin® v3.8.5, Copyright ©2000-2012, Jelsoft Enterprises Ltd.